Disable the "lacp-individual" command on configured switches
Suggest changes
PDFs
By default, the Mellanox switch lacp-individual command and the Cisco switch lacp suspend-individual command remain configured post deployment. This command is not required post installation; if it remains configured, it can cause volume access issues when troubleshooting or rebooting a switch. Post deployment, you should check each Mellanox switch and Cisco switch configuration and remove the lacp-individual or lacp suspend-individual command.
-
Using SSH, open a session to the switch.
-
Show the running configuration:
show running-config -
Check the switch configuration output for the
lacp-individualorlacp suspend-individualcommand.
The xxx-xxxis your user supplied interface number(s). If required, you can access the interface number by displaying the Multi-chassis Link Aggregation Group interfaces:show mlag interfaces-
For a Mellanox switch, check if the output contains the following line:
interface mlag-port-channel xxx-xxx lacp-individual enable force -
For a Cisco switch, check if the output contains the following line:
interface mlag-port-channel xxx-xxx lacp suspend-individual enable force
-
-
If the command is present, remove it from the configuration.
-
For a Mellanox switch:
no interface mlag-port-channel xxx-xxx lacp-individual enable force -
For a Cisco switch:
no interface mlag-port-channel xxx-xxx lacp suspend-individual enable force
-
-
Repeat these steps for each switch in your configuration.