Checking supported configurations for FLI using the SAN LUN Migrate App

Contributors Download PDF of this page

Beginning in ONTAP 9.9.1, you can use the SAN LUN Migrate App to qualify a foreign source array for FLI. The SAN LUN Migrate App can be used when the desired foreign array is not listed in the FLI IMT.

Steps
  1. Go to the NetApp Support Site.

  2. Under Filter by category, select Migration.

  3. Under SAN LUN Migration, clickDownload App.

  4. Run the app from a FC or iSCSI Linux host that has block access to the source array.

    If the foreign source array can be qualified, a green check mark is displayed. If the foreign source array cannot be qualified, a red X is displayed. If your array does not qualify, you can contact NetApp Support for additional assistance.