Skip to main content
BlueXP classification

Reducing the BlueXP classification scan speed

Contributors netapp-tonacki amgrissino
PDFs

Data scans have a negligible impact on your storage systems and on your data. However, if you are concerned with even a very small impact, you can configure BlueXP classification to perform "slow" scans.

When enabled, slow scanning is used on all data sources - you can't configure slow scanning for a single working environment or data source.

Tip The scan speed can't be reduced when scanning databases.

NOTE This information is relevant only for BlueXP classification legacy versions 1.30 and earlier.

Steps

  1. From the bottom of the Configuration page, move the slider to the right to activate slow scanning.

    A screenshot showing how to enable slow compliance scanning.

    The top of the Configuration page indicates that slow scanning is enabled.

    A screenshot showing how to enable slow compliance scanning.

  2. You can disable slow scanning by clicking Disable from this message.