Skip to main content
SnapCenter Software 4.6
A newer release of this product is available.

Delete clones

Contributors netapp-soumikd
PDFs

You can delete clones if you find them no longer necessary.

About this task

You cannot delete clones that acts like source for other clones.

For example, if the production database is db1, database clone1 is cloned from backup of db1 and subsequently clone1 is protected. The database clone2 is cloned from backup of clone1. If you decide to delete clone1, you must first delete clone2, and then delete clone1.

Steps

  1. In the left navigation pane, click Resources, and then select the appropriate plug-in from the list.

  2. In the Resources page, either select the resource or resource group from the View drop-down list.

  3. Select the resource or resource group from the list.

    The resource or the resource group topology page is displayed.

  4. From the Manage Copies view, select Clones either from the primary or secondary (mirrored or replicated) storage systems.

  5. Select the clone, and then click delete icon.

    If you are deleting SAP HANA database clones, in the Delete Clone page, perform the following actions:

    1. In the Pre clone delete field, enter the commands that should be run before deleting the clone.

    2. In the Unmount field, enter the command to unmount the clone before deleting the clone.

  6. Click OK.

After you finish

Sometimes the file systems are not deleted. You must increase the value of the CLONE_DELETE_DELAY parameter by running the following command:./sccli Set-SmConfigSettings

Note The CLONE_DELETE_DELAY parameter specifies the number of seconds to wait after completing the deletion of application clone and before starting the deletion of file system.

After modifying the value of the parameter, restart the SnapCenter Plug-in Loader (SPL) service.