Installation and Setup for UNIX for Clustered Data ONTAP
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
Add storage systems operating in clustered Data ONTAP to the SnapManager server host
Contributors
Suggest changes
-
PDF of this doc site
-
Administration for UNIX
-
Installation and Administration for Windows
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You must add the storage systems operating in clustered Data ONTAP to the SnapManager server host to enable AutoSupport. In SnapManager 3.3 and earlier, AutoSupport was supported only on storage systems operating in 7-Mode.
Steps
-
Add an Admin Storage Virtual Machine (SVM, formerly known as Vserver) and a SVM operating in clustered Data ONTAP to the SnapManager server host:
sdcli transport_protocol set -f AdminVserver_name or Vserver_name -type HTTP -user adminThe enter the following command: message is displayed.
-
Enter the password that you provided while creating SVM.
After you run the command successfully, the New transport protocol has been set. message is displayed.
