Get started
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
A newer release of this product is available.
Install Linux
Contributors
Suggest changes
-
PDF of this doc site
-
Install, upgrade, and hotfix
-
Configure and manage
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You must install StorageGRID on all Red Hat Enterprise Linux grid hosts. For a list of supported versions, use the NetApp Interoperability Matrix Tool.
|
Ensure that your operating system is upgraded to Linux kernel 4.15 or higher. |
Steps
-
Install Linux on all physical or virtual grid hosts according to the distributor's instructions or your standard procedure.
If you are using the standard Linux installer, NetApp recommends selecting the "compute node" software configuration, if available, or "minimal install" base environment. Don't install any graphical desktop environments. -
Ensure that all hosts have access to package repositories, including the Extras channel.
You might need these additional packages later in this installation procedure.
-
If swap is enabled:
-
Run the following command:
$ sudo swapoff --all -
Remove all swap entries from
/etc/fstabto persist the settings.
Failing to disable swap entirely can severely lower performance. -
