Provision NAS storage
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
Generate an AutoSupport message about starting expansion
Contributors
Suggest changes
-
PDF of this doc site
-
Provision NAS storage
-
Provision SAN storage
-
Data protection and disaster recovery
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
Immediately before you expand a cluster, you should send an AutoSupport message to indicate that you are about to start the expansion process. The message informs internal and external support staff about expansion and acts as a timestamp for any troubleshooting that might be required later.
Before you begin
AutoSupport must be set up.
Steps
-
For each node in the cluster, send an AutoSupport message by using the
system node autosupport invokecommand.cluster1::> system node autosupport invoke -node * -message "cluster expansion started" -type all The AutoSupport was successfully invoked on node "cluster1-1". To view the status of the AutoSupport, use the "system node autosupport history show" command. Note: It may take several minutes for the AutoSupport to appear in the history list. The AutoSupport was successfully invoked on node "cluster1-2". To view the status of the AutoSupport, use the "system node autosupport history show" command. Note: It may take several minutes for the AutoSupport to appear in the history list. 2 entries were acted on.
