Enables you to perform an automated cluster update nondisruptively or you can update single-node clusters disruptively.

Displays the details of previous cluster updates.

Updates the information in the window.

You can select the version of the software image for the update.

You can view and validate the cluster against the software image version for the update. A pre-update validation checks whether the cluster is in a state that is ready for an update. If the validation is completed with errors, a table displays the status of the various components and the required corrective action for the errors.

You can perform the update only when the validation is completed successfully.

You can update all of the nodes in the cluster or an HA pair in the cluster to the selected version of the software image. While the update is in progress, you can choose to pause the update, and you can then either cancel or resume the update.

If an error occurs, the update is paused and an error message is displayed with the remedial steps. You can choose to either resume the update after performing the remedial steps or cancel the update. You can view the table with the node name, uptime, state, and ONTAP version when the update is successfully completed.

Specifies the version of the ONTAP image to which the node will be updated.

Specifies the type of disk on which the updates are installed.

Specifies the status of the software image update (whether the update is successful or cancelled).

Specifies the time when the update was started.

Specifies the time when the update was completed.

This field is hidden by default.

Specifies the time taken for the update to finish.

Specifies the ONTAP version of the node before the update.

Specifies the ONTAP version of the node after the update.