Testing the data source configuration
Contributors
Suggest changes
-
PDF of this doc site
- Configuration and administration
- Data Warehouse administration
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
When you are adding a data source, you can verify the correctness of configuration to communicate with the device before saving or updating that data source.
When you click the Test button in the data source wizard, communication with the specified device is checked. The test produces one of these results:
-
PASSED: the data source is configured correctly.
-
WARNING: the testing was incomplete, probably due to timing out during processing or acquisition not running.
-
FAILED: the data source, as configured, cannot communicate with the specified device. Check your configuration settings and re-test.