Skip to main content
ONTAP MetroCluster
La versione in lingua italiana fornita proviene da una traduzione automatica. Per eventuali incoerenze, fare riferimento alla versione in lingua inglese.

Ripristino delle impostazioni predefinite di sistema su un modulo controller

Collaboratori

Ripristinare le impostazioni predefinite dei moduli controller.

  1. Al prompt DEL CARICATORE, riportare le variabili ambientali alle impostazioni predefinite: set-defaults

  2. Avviare il nodo dal menu di boot: boot_ontap menu

    Dopo aver eseguito questo comando, attendere che venga visualizzato il menu di avvio.

  3. Cancellare la configurazione del nodo:

    • Se si utilizzano sistemi configurati per ADP, selezionare l'opzione 9a dal menu di avvio e rispondere no quando richiesto.

      Nota Questo processo è disgregativo.

      La seguente schermata mostra il prompt del menu di avvio:

      Please choose one of the following:
      
      (1) Normal Boot.
      (2) Boot without /etc/rc.
      (3) Change password.
      (4) Clean configuration and initialize all disks.
      (5) Maintenance mode boot.
      (6) Update flash from backup config.
      (7) Install new software first.
      (8) Reboot node.
      (9) Configure Advanced Drive Partitioning.
      (10) Set Onboard Key Manager recovery secrets.
      (11) Configure node for external key management.
      Selection (1-11)? 9a
      ...
      
      ########## WARNING: AGGREGATES WILL BE DESTROYED ##########
      This is a disruptive operation that applies to all the disks
      that are attached and visible to this node.
      
      Before proceeding further, make sure that:
      
      The aggregates visible from this node do not contain
      data that needs to be preserved.
      This option (9a) has been executed or will be executed
      on the HA partner node (and DR/DR-AUX partner nodes if
      applicable), prior to reinitializing any system in the
      HA-pair or MetroCluster configuration.
      The HA partner node (and DR/DR-AUX partner nodes if
      applicable) is currently waiting at the boot menu.
      Do you want to abort this operation (yes/no)? no
    • Se il sistema non è configurato per ADP, digitare wipeconfig Al prompt del menu di avvio, quindi premere Invio.

      La seguente schermata mostra il prompt del menu di avvio:

    Please choose one of the following:
    
        (1) Normal Boot.
        (2) Boot without /etc/rc.
        (3) Change password.
        (4) Clean configuration and initialize all disks.
        (5) Maintenance mode boot.
        (6) Update flash from backup config.
        (7) Install new software first.
        (8) Reboot node.
        (9) Configure Advanced Drive Partitioning.
        Selection (1-9)?  wipeconfig
    This option deletes critical system configuration, including cluster membership.
    Warning: do not run this option on a HA node that has been taken over.
    Are you sure you want to continue?: yes
    Rebooting to finish wipeconfig request.