Turning the controller identify LED on and off

The blue identify LED on the front and back of the controller can be turned on to help locate the appliance in a data center.

Before you begin

You must have the BMC IP address of the controller you want to identify.


  1. Access the controller BMC interface.
  2. Select Server Identify.
  3. Select ON and then select Perform Action.

    Turn on controller identify LED from BMC


The blue identify LEDs light on the front (shown) and rear of the controller.

Front identify LED - on
Note: If a bezel is installed on the controller, it might be difficult to see the front identify LED.

After you finish

To turn off the controller identify LED:

The blue identify LEDs on the front and rear of the controller go off.

Front identify LED - off