Get started
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
A newer release of this product is available.
Recovering nodes that fail to start normally
Contributors
Suggest changes
-
PDF of this doc site
-
Install and upgrade software
-
Install and maintain hardware
-
SG5700 storage appliances
-
SG5600 storage appliances
-
-
Configure and manage
-
Administer StorageGRID
-
-
Use StorageGRID
-
Monitor and troubleshoot
-
Monitor a StorageGRID system
-
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
If a StorageGRID node does not rejoin the grid normally and does not show up as recoverable, it may be corrupted. You can force the node into recovery mode.
To force the node into recovery mode:
sudo storagegrid node force-recovery node-name
|
Before issuing this command, confirm that the node's network configuration is correct; it may have failed to rejoin the grid due to incorrect network interface mappings or an incorrect Grid Network IP address or gateway. |
|
After issuing the storagegrid node force-recovery node-name command, you must perform additional recovery steps for node-name.
|
Related information
What's next: Performing additional recovery steps, if required
