Creating data aggregates on, implementing, and verifying the MetroCluster configuration
Suggest changes
-
PDF of this doc site
- Install a fabric-attached MetroCluster
- Install a MetroCluster IP configuration
- Install a stretch MetroCluster configuration
- Transition from MetroCluster FC to MetroCluster IP
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You must create data aggregates on each node, implement, and verify the MetroCluster configuration.
Steps
-
Create data aggregates on each node:
-
Create a mirrored data aggregate on each node:
-
If needed, create unmirrored data aggregates:
-
-
Configure the MetroCluster FC switches for health monitoring.
-
Check and verify the configuration:
-
Install and configure the MetroCluster Tiebreaker software:
-
Set the destination for configuration backup files: