Install a fabric-attached MetroCluster
Setting the HA mode on the existing controller module
Contributors
Suggest changes
-
PDF of this doc site
-
Install a fabric-attached MetroCluster
-
Install a stretch MetroCluster configuration
-
Transition from MetroCluster FC to MetroCluster IP
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You must use the storage failover modify command to set the mode on the existing controller module. The mode value is enabled later, after you reboot the controller module.
Steps
-
Set the mode to HA:
storage failover modify -mode ha -node existing_node_name