Sending a custom AutoSupport message after maintenance
Suggest changes
-
PDF of this doc site
- Install a fabric-attached MetroCluster
- Install a MetroCluster IP configuration
- Install a stretch MetroCluster configuration
- Transition from MetroCluster FC to MetroCluster IP
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
After completing the transition, you should send an AutoSupport message indicating the end of maintenance, so automatic case creation can resume.
-
To resume automatic support case generation, send an Autosupport message to indicate that the maintenance is complete.
-
Issue the following command:
system node autosupport invoke -node * -type all -message MAINT=end
-
Repeat the command on the partner cluster.
-