Clearing the configuration on a controller module
Suggest changes
-
PDF of this doc site
- Install a fabric-attached MetroCluster
- Install a MetroCluster IP configuration
- Install a stretch MetroCluster configuration
- Transition from MetroCluster FC to MetroCluster IP
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
Before using a new controller module in the MetroCluster configuration, you must clear the existing configuration.
Steps
-
If necessary, halt the node to display the LOADER prompt:
halt
-
At the LOADER prompt, set the environmental variables to default values:
set-defaults
-
Save the environment:
saveenv
-
At the LOADER prompt, launch the boot menu:
boot_ontap menu
-
At the boot menu prompt, clear the configuration:
wipeconfig
Respond
yes
to the confirmation prompt.The node reboots and the boot menu is displayed again.
-
At the boot menu, select option 5 to boot the system into Maintenance mode.
Respond
yes
to the confirmation prompt.