Install and and Setup for Linux for Clustered Data ONTAP
SnapRestore and Snapconnect operations does not work in Linux after multipathing type migration
Contributors
Suggest changes
-
PDF of this doc site
-
Administration for Linux
-
Role-based access control in SnapDrive for UNIX
-
-
Installation and Administration for Solaris
-
Role-based access control in SnapDrive for UNIX
-
Creating and using Snapshot copies in SnapDrive for UNIX
-
-
Installation and Administration for IBM AIX
-
Role-based access control in SnapDrive for UNIX
-
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
The SnapRestore and SnapConnect operations does not work if the multipathing type is migrated.
If you have an existing multipathing type set as None, and later you tend to change the multipathing type as NativeMPIO, when you execute Snapconnect and SnapRestore operations for the existing Snapshot copies, you might encounter an error message as "Unable to find multipathing software linuxnull as present in the snapshot".
Example for SnapRestore operation
snapdrive snap restore -fs /mnt/tstmp -snapname withoutmpio 0002-105 Command error: Unable to find multipathing software linuxnull as present in the snapshot
Example for Snapconnect operation
snapdrive snap connect -fs /mnt/tstmp -snapname f3020-225-54:/vol/vol1:withoutmpio -autorename 0002-105 Command error: Unable to find multipathing software linuxnull as present in the snapshot