Get started
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
A newer release of this product is available.
Turn controller identify LED on and off
Contributors
Suggest changes
-
PDF of this doc site
-
Install and upgrade
-
Configure and manage
-
Maintain
-
Recover nodes and maintain your grid
-
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
The blue identify LED on the front and back of the controller can be turned on to help locate the appliance in a data center.
Before you begin
You have the BMC IP address of the controller you want to identify.
Steps
-
Access the appliance BMC interface.
-
Select Server Identify.
The current status of the identify LED is selected.
-
Select ON or OFF, and then select Perform Action.
When you select ON, the blue identify LEDs light on the front (shown) and rear of the appliance.
If a bezel is installed on the controller, it might be difficult to see the front identify LED. -
Turn the LED on and off as needed.
Related information
