Get started
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
A newer release of this product is available.
View boot-up status and reviewing error codes on SG5600 controllers
Contributors
Suggest changes
-
PDF of this doc site
-
Install and maintain appliance hardware
-
SG100 and SG1000 services appliances
-
-
Install and upgrade software
-
Perform system administration
-
Monitor and maintain StorageGRID
-
Recover and maintain
-
Grid node recovery procedures
-
-
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
The seven-segment display on each controller shows status and error codes when the appliance powers up, while the hardware is initializing, and when the hardware fails and must back out of the initialization. If you are monitoring the progress or troubleshooting, you should watch the sequence of the codes as they appear.
About this task
The status and error codes for the E5600SG controller are not the same as those for the E2700 controller.
Steps
-
During boot-up, view the codes shown on the seven-segment displays to monitor progress.
-
To review error codes for the E5600SG controller, see the seven-segment display status and error code information.
-
To review error codes for the E2700 controller, see the E2700 controller documentation on the Support Site.
Related information
