Get started
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
A newer release of this product is available.
VLST: User Initiated Volume Lost
Contributors
Suggest changes
-
PDF of this doc site
-
Install and maintain appliance hardware
-
SG100 and SG1000 services appliances
-
-
Install and upgrade software
-
Perform system administration
-
Monitor and maintain StorageGRID
-
Recover and maintain
-
Grid node recovery procedures
-
-
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
This message is issued whenever the /proc/CMSI/Volume_Lost command is run.
| Code | Field | Description |
|---|---|---|
VOLL |
Volume Identifier Lower |
The lower end of the affected volume range or a single volume. |
VOLU |
Volume Identifier Upper |
The upper end of the affected volume range. Equal to VOLL if a single volume. |
NOID |
Source Node ID |
The node ID on which the locations were lost. |
LTYP |
Location Type |
'CLDI' (Online) or 'CLNL' (Nearline). If not specified, defaults to 'CLDI'. |
RSLT |
Result |
Always 'NONE'. RSLT is a mandatory message field, but is not relevant for this message. 'NONE' is used rather than 'SUCS' so that this message is not filtered. |
