accesscache events
A newer release of this product is available.
sp.wdog events
Contributors
Suggest changes
PDFs
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
sp.wdog.set.fail
- Severity
-
ERROR
- Description
-
This message occurs when ONTAP® software fails to disable or enable the service-processor' (SP or BMC) watchdog timer. This might occur due to an intermittent SP or BMC firmware failure.
- Corrective Action
-
If the system continues to run normally, you can ignore this message. If a system disruption occurs after this failure, reboot the SP or BMC or power-cycle the system before starting ONTAP or performing a giveback. If system disruptions continue to occur, contact NetApp technical support for assistance.
- Syslog Message
-
Unable to %s service-processor's watchdog timer. Error code: 0x%x.
- Parameters
-
op (STRING): Whether the failure was to enable or disable the timer.
errcode (INT): Error code for debugging.