Show SNMPv3 USM user - SANtricity CLI

05/27/2025 Contributors

The show allsnmpUsers command returns information about the Simple Network Management (SNMP) USM users defined for the storage array.

Supported Arrays

This command applies to an individual E4000, E2800, E5700, EF600 or EF300 storage array. It does not operate on E2700 or E5600 storage arrays.

Roles

To execute this command on an E4000, E2800, E5700, EF600, or EF300 storage array, you must have the Storage Admin or Support Admin role.

Syntax

show (allSnmpUsers |
    snmpUser userName="snmpUsername" |
    snmpUsers [snmpUserName1 ... snmpUserNameN])
    [summary]

This command returns SNMP user information similar to the following

SNMP USERS------------------------------

SUMMARY

   Total SNMP Users: 2
   Total SNMP Trap Destinations: 1

DETAILS

   SNMP User: TestUser1
   SNMP Engine ID: local
   SNMP Permission: Read Only
   SNMP Authentication Protocol: sha
   SNMP Privacy Protocol: aes128

      Associated Trap Destination:

      Trap Receiver IP Address  Send Authentication Failure Traps
      10.113.173.133            false

   SNMP User: TestUser2
   SNMP Engine ID: local
   SNMP Permission: Read Only
   SNMP Authentication Protocol: sha256
   SNMP Privacy Protocol: none

      Associated Trap Destination:

Parameters

Parameter Description

Parameter	Description
`allSnmpUsers`	This parameter returns information about all of the SNMP users in the storage array.
`userName`	The name of the SNMP user for which you want to retrieve information. Enclose the SNMP user name in double quotation marks (" ").
`snmpUsers`	The names of several SNMP users for which you want to retrieve information. Enter the names of the SNMP users using these rules: Enclose all of the names in square brackets ([ ]). Enclose each of the names in double quotation marks (" "). Separate each of the names with a space.
`summary`	This parameter returns a list of the total number of SNMP users and the total number of SNMP trap destinations. When you use this parameter, all of the detail information is omitted.

allSnmpUsers

This parameter returns information about all of the SNMP users in the storage array.

userName

The name of the SNMP user for which you want to retrieve information. Enclose the SNMP user name in double quotation marks (" ").

snmpUsers

The names of several SNMP users for which you want to retrieve information. Enter the names of the SNMP users using these rules:

Enclose all of the names in square brackets ([ ]).
Enclose each of the names in double quotation marks (" ").
Separate each of the names with a space.

summary

This parameter returns a list of the total number of SNMP users and the total number of SNMP trap destinations. When you use this parameter, all of the detail information is omitted.

Minimum firmware level

8.72