Show synchronous mirroring volume synchronization progress

09/10/2024 Contributors

The show syncMirror synchronizationProgress command returns the progress of data synchronization between the primary volume and the secondary volume in a Synchronous Mirroring configuration.

Supported Arrays

This command applies to any individual storage array, including the E4000, E2700, E5600, E2800, and E5700 arrays, as long as all SMcli packages are installed.

Roles

To execute this command on an E4000, E2800, or E5700 storage array, you must have the Storage Admin or Storage Monitor role.

Context

This command shows the progress as a percentage of data synchronization that has been completed.

In previous versions of this command the feature identifier was remoteMirror. This feature identifier is no longer valid and is replaced by syncMirror.

Syntax

show syncMirror (localVolume [volumeName] |
localVolumes [volumeName1... volumeNameN]) synchronizationProgress

Parameter

Parameter Description

Parameter	Description
`volume`	The name of the primary volume of the remote mirrored pair for which you want to check synchronization progress. Enclose the volume name in square brackets ([ ]). If the volume name has special characters or numbers, you must enclose the volume name in double quotation marks (" ") inside square brackets.
`volumes`	The names of the primary volume of the remote mirrored pair for which you want to check synchronization progress. Enter the names of the volumes using these rules: Enclose all of the names in square brackets ([ ]). Separate each of the names with a space. If the volume names have special characters or consist only of numbers, enter the names using these rules: Enclose all of the names in square brackets ([ ]). Enclose each of the names in double quotation marks (" "). Separate each of the names with a space.

volume

The name of the primary volume of the remote mirrored pair for which you want to check synchronization progress. Enclose the volume name in square brackets ([ ]). If the volume name has special characters or numbers, you must enclose the volume name in double quotation marks (" ") inside square brackets.

volumes

The names of the primary volume of the remote mirrored pair for which you want to check synchronization progress. Enter the names of the volumes using these rules:

Enclose all of the names in square brackets ([ ]).
Separate each of the names with a space.

If the volume names have special characters or consist only of numbers, enter the names using these rules:

Enclose all of the names in square brackets ([ ]).
Enclose each of the names in double quotation marks (" ").
Separate each of the names with a space.

Minimum firmware level

5.40