Skip to main content
SANtricity commands

Add array label

Contributors netapp-driley

The Add array label command allows you to add a storage array to the configuration with a user-defined label. This allows later commands to address the storage array by the user-defined label rather than by IP address or host name.

Supported Arrays

Note

The user-defined label provided does not need to match the storage array's name as displayed in System Manager. This is a local label that is only used for referencing the storage array from the CLI.

This command applies to the EF600 and EF300 storage arrays.

Syntax

 Address1 Address2 add storageArrayLabel label userDefinedString

Parameters

Parameter Description

Address

Allows you to specify the IP address (IPv4 or IPv6) or fully qualified host name for the storage array.

Note

The Address2 value is optional.

userDefinedString

Allows you to specify a label for the storage array.

Minimum firmware level

8.60