Reset storage array diagnostic data
The reset storageArray diagnosticData
command resets the NVSRAM that contains the diagnostic data for the storage array.
Supported Arrays
This command applies to any individual storage array, including the E4000, E2700, E5600, E2800, E5700, EF600 and EF300 arrays, as long as all SMcli packages are installed.
Roles
To execute this command on an E4000, E2800, E5700, EF600, or EF300 storage array, you must have the Storage Admin role.
Context
This command does not delete the diagnostic data. This command replaces the Needs Attention status with the Diagnostic Data Available status. The old diagnostic data is written over automatically when new data is captured. The memory that contains the diagnostic data is also cleared when the controllers reboot. Before you reset the diagnostic data, use the save storageArray diagnosticData
command to save the diagnostic data to a file.
Run this command only with the assistance of technical support. |
Syntax
reset storageArray diagnosticData
Parameters
None.
Minimum firmware level
6.16