Change the CNA/UTA2 target adapter optical modules
Suggest changes
-
PDF of this doc site
- Cluster administration
-
Volume administration
- Logical storage management with the CLI
-
NAS storage management
- Configure NFS with the CLI
- Manage NFS with the CLI
-
Manage SMB with the CLI
- Manage file access using SMB
- Security and data encryption
- Data protection and disaster recovery
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You should change the optical modules on the unified target adapter (CNA/UTA2) to support the personality mode you have selected for the adapter.
Steps
-
Verify the current SFP+ used in the card. Then, replace the current SFP+ with the appropriate SFP+ for the preferred personality (FC or CNA).
-
Remove the current optical modules from the X1143A-R6 adapter.
-
Insert the correct modules for your preferred personality mode (FC or CNA) optics.
-
Verify that you have the correct SFP+ installed:
network fcp adapter show -instance -node -adapter
Supported SFP+ modules and Cisco-branded Copper (Twinax) cables are listed in the NetApp Hardware Universe.