Failed to initialize restore stream
Contributors
Suggest changes
-
PDF of this doc site
- Cluster administration
-
Volume administration
- Logical storage management with the CLI
-
NAS storage management
- Configure NFS with the CLI
- Manage NFS with the CLI
-
Manage SMB with the CLI
- Manage file access using SMB
- SAN storage management
- Security and data encryption
-
Data protection and disaster recovery
- Data protection with the CLI
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
-
Message
Failed to initialize restore stream
-
Cause
You might get this error message for one of the following reasons:
-
The backup image is not of SMTape.
-
The tape blocking factor specified is incorrect.
-
The tape is corrupt or damaged.
-
The wrong tape is loaded for restore.
-
-
Corrective action
-
If the backup image is not of SMTape, retry the operation with a tape that has the SMTape backup.
-
If the blocking factor is incorrect, specify the correct blocking factor and retry the operation.
-
If the tape is corrupt, you cannot perform the restore operation.
-
If the wrong tape is loaded, retry the operation with the correct tape.
-