Release notes
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
Check for specific ONTAP configurations after an upgrade
Contributors
Suggest changes
-
PDF of this doc site
-
Cluster administration
-
Volume administration
-
Logical storage management with the CLI
-
-
NAS storage management
-
Configure NFS with the CLI
-
Manage NFS with the CLI
-
Manage SMB with the CLI
-
Manage file access using SMB
-
-
-
Security and data encryption
-
Data protection and disaster recovery
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
If your cluster is configured with any of the following features you might need to perform additional steps after you upgrade your ONTAP software.
| Ask yourself… | If your answer is yes, then do this… |
|---|---|
Did I upgrade from ONTAP 9.7 or earlier to ONTAP 9.8 or later? |
|
Is my cluster in a a MetroCluster configuration? |
|
Do I have a SAN configuration? |
|
Did I upgrade from ONTAP 9.3 or earlier, and am using NetApp Storage Encryption? |
|
Do I have load-sharing mirrors? |
|
Do I have user accounts for Service Processor (SP) access that were created prior to ONTAP 9.9.1? |
Verify the change in accounts that can access the Service Processor |
