Release notes
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
Configure the ports
Contributors
Suggest changes
-
PDF of this doc site
-
Cluster administration
-
Volume administration
-
Logical storage management with the CLI
-
-
NAS storage management
-
Configure NFS with the CLI
-
Manage NFS with the CLI
-
Manage SMB with the CLI
-
Manage file access using SMB
-
-
-
Security and data encryption
-
Data protection and disaster recovery
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
To configure the unified target adapter (X1143A-R6), you must configure the two adjacent ports on the same chip in the same personality mode.
Steps
-
Configure the ports as needed for Fibre Channel (FC) or Converged Network Adapter (CNA) using the
system node hardware unified-connect modifycommand. -
Attach the appropriate cables for FC or 10 Gb Ethernet.
-
Verify that you have the correct SFP+ installed:
network fcp adapter show -instance -node -adapterFor CNA, you should use a 10Gb Ethernet SFP. For FC, you should either use an 8 Gb SFP or a 16 Gb SFP, based on the FC fabric being connected to.
