Set the time zone for a cluster with System Manager - ONTAP 9.7 and earlier
PDF of this doc site
Provision NAS storage
- NFS configuration
- NFS configuration for ESXi using VSC
- SMB/CIFS and NFS multiprotocol configuration
Provision SAN storage
- FC configuration for Red Hat Enterprise Linux
- iSCSI configuration for ESXi using VSC
- iSCSI configuration for Red Hat Enterprise Linux
Data protection and disaster recovery
- Cluster and SVM peering configuration
- Volume disaster recovery
- Cluster administration
Cluster management using System Manager 9.6 and 9.7
- Cluster management using System Manager 9.6 and 9.7
- Provision NAS storage
You can manually set or modify the time zone for a cluster by using the Edit Date and Time dialog box in ONTAP System Manager classic (available in ONTAP 9.7 and earlier). You can also add time servers to the cluster.
Network Time Protocol (NTP) is always enabled on a cluster. You can disable NTP, but it is not recommended.
You can add the IP addresses of the NTP server at your site. This server is used to synchronize the time across the cluster.
You can specify either an IPv4 address or an IPv6 address for the time server.
In the Setup panel, click Date and Time.
In the Edit Date and Time dialog box, select the time zone.
Specify the IP address of the time servers, and then click Add.
Verify the changes that you made to the time settings in the Date and Time window.